A new phenomenom is propagating over the web, and elsewhere: "Vinyl Toys" or "Art Toys". To make it short, there are "virgin" toys that you customize yourself.
I propose to do it on an egg ; everybody can participate with a low production cost.( an egg costs a few cents)
The goal is also to gather as most participants as possible.
Once finished, send it and i'll add it to the worm .
If you want to go further and get a better conservation of the egg, make what follows:

You need :

• water
• 1 straw
• 1 needle
• 1 soup spoon
• 1/2 toilet paper roll
• 2 bowls
• modelling plaster
• adhesive tape
• and 1 egg

1 dig 2 holes with the needle; beware of cracks it's extremely fragile.

2 put the straw on one hole and blow to push out the egg off the eggshell.

3 put the egg on the half toilet paper roll patch the lower hole with the adhesive tape; make sure that the higher hole is as large as the straw diameter.

4 pour 4-5 soup spoon of water in a bowl then 3 s.s of plaster, mix it. It mustn't be too solid.

5 Suck the mix on the straw and blow it into the eggshell. do not eat it, it doesn't taste good ^_^

6 clean the egg , remove the adhesive tape; make sure that the lower hole is the lowest point of the egg . Let dry 2-3 days. ready to decorate ! .